This module allows connecting devices with 0-10V input interface to the Smart Home system.


Connection of 4 0-10V devices

Module parameters

Parameter name Value
Outputs channel quantity 4
Max load per channel 15mA
Power supply 11.5 … 27.5 V DC from CAN
Max current(24V) 50mA
Bus type CAN (4-wire)
Equipment installation type DIN-rail (EN 60715)
Case material ABS
Protection IP40
Temperature range -10 … +50 °C
Size 2U, 36x97x58 mm
Weight 130g

Indication of module operation.

Indicator Status Description
Power Power
Power not available
Activity Transferring data
No data transferring
Error No errors


The device blinks once every two seconds. The data has not been transferred via the CAN bus for at least 5 minutes.

Module installation and connection procedure

  1. Install the module in the switchboard on the DIN rail and fix it with the special latch on the module base.
  2. Connect the X1 connector.
  3. Connect the CAN connectors.
  4. Configure the module using LT setup.
  5. Check all equipment for proper operation.

Module shut-off and deinstallation procedure

  1. Disconnect the connectors CAN.
  2. Disconnect the X1 connector.
  3. Remove the module from the DIN rail, releasing the latch at the bottom of the module base.


<item addr="40:1" auto-period="600" cfgid="79" name="Dimmer" type="dimer-lamp" uniq_id="87"/>
<item addr="40:2" auto-period="600" cfgid="79" name="Dimmer" type="dimer-lamp" uniq_id="88"/>
<item addr="40:3" auto-period="600" cfgid="79" name="Dimmer" type="dimer-lamp" uniq_id="89"/>
<item addr="40:4" auto-period="600" cfgid="79" name="Dimmer" type="dimer-lamp" uniq_id="90"/>
<item addr="40:98" cfgid="79" name="Temperature" system="yes" type="temperature-sensor" uniq_id="91"/>