6-CHANNEL I/O MODULE

The module is designed for connection of other digital devices which
do not have standard interfaces

Connection example

Module parameters

Parameter name Value
Input channels qty 3
Output channels qty 3
Voltage that may be applied to the input channels 0…15 V DC
Max output switching voltage 60V AC/DC
Max output switching current 50mA
Power supply 11.5 … 27.5 V DC from CAN
Max current(24V) 25 mA
Bus type CAN (4-wire)
Mounting Free
Case material ABS
Protection IP40
Temperature range -10 … +50 °C
Size 45x42x14 mm
Weight 15 g

Module installation and connection procedure

  1. Connect the inputs.
  2. Connect the outputs.
  3. Connect the CAN connector.
  4. Configure the module using LT setup.
  5. Check all equipment for proper operation.

Module shut-off and deinstallation procedure

  1. Disconnect the CAN connector.
  2. Disconnect the inputs.
  3. Disconnect the outputs.

 

HW Settings

Name Type, range SUBID Default Description
io char[6] 98 'HHHLLL' Each char is responsible for the type of a particular channel

    1-3 channels

  • ‘H’ – Contact
  • ‘K’ – Inverted contact
  • ‘L’ – Backlit button
  • ‘M’ – Inverted backlit button
    4-6 channels

  • ‘L’-Lamp
  • ‘M’-Lamp Inverse;
  • ‘J’-Heating NO, valve-heating, normally open;
  • ‘H’-Heating NC, valve-heating, normally closed;
  • ‘B’-Blinds, jalousie/curtains(2 pole);
  • ‘C’-Blinds Inverse, jalousie/curtains, invert open-close(2 pole);
  • ‘G’-Gate (2 pole), 2 pole gate;
  • ‘D’-Gate (2 pole) Inverse, 2 pole gate, invert open-close;
  • ‘X’-Gate (1 pole /short press), 1 pole gate;
  • ‘Z’-Gate (1 pole) Inverse, 1 pole gate, invert open-close;
  • ‘V’-Valve (2 pole), 2 pole valve,;
  • ‘W’-Valve (2 pole) Inverse, 2 pole valve, invert open-close;
  • ‘R’-Valve (1 pole), 1 pole valve;
  • ‘S’-Valve (1 pole) Inverse, 1 pole valve, invert open-close;
  • ‘K’-Lock (short press);
  • ‘N’-Lock (short press) Inverse;
  • ‘F’-FanCoil. Group1 (Lamp Toggle). For fancoil speed control;
  • ‘E’-FanCoil. Group2 (Lamp Toggle). For fancoil speed control;
  • ‘Q’-FanCoil. Group3 (Lamp Toggle). For fancoil speed control;
  • ‘U’-FanCoil. Group4 (Lamp Toggle). For fancoil speed control;
  • ‘I’-FanCoil. Group5 (Lamp Toggle). For fancoil speed control;
  • ‘-‘-none, nothing is connected.

Example: 

hw="io='KKKLLL'"