https://wiki.larnitech.com/index.php?action=history&feed=atom&title=BW-AC%2FenBW-AC/en - Revision history2026-05-19T03:16:02ZRevision history for this page on the wikiMediaWiki 1.35.11https://wiki.larnitech.com/index.php?title=BW-AC/en&diff=6623&oldid=prevFuzzyBot: Updating to match new version of source page2022-01-09T14:19:11Z<p>Updating to match new version of source page</p>
<p><b>New page</b></p><div><languages/><br />
{{Infobox module<br />
| name = BW-AC.C<br />
| image = BW-ACC.png<br />
| UART = 1<br />
| voltage = 11.5...27.5 V DC<br />
| dim = 45x42x14 mm<br />
}}<br />
<br />
==AC ADAPTER==<br />
<br />
This module is designed for integration Mitsubishi AC (connector CN105, CN92), Daikin AC (connector S21) to the Smart Home system.<br />
<br />
<div class="caution"><br />
CAUTION! All work related to the installation, connection, setting up, service and support must be carried out by qualified personnel with sufficient skills and experience in working with electrical equipment.<br />
To avoid the risk of fire, electric shock, damage to the system and/or personal injury, the system installation and assembly must be performed in accordance with the instructions listed below:<br />
*all connectivity work must be carried out with the power turned OFF;<br />
*use appropriate tools and personal protection against electric shock;<br />
*do not use damaged cables, wires and connectors;<br />
*avoid folding the cables and wires;<br />
*do not apply excessive force to the wires by kinking or pressing them too hard: the inner conductors of the cables and wires may get stripped or damaged;<br />
*do not use the power socket with poor contacts to connect;<br />
*do not exceed the load limit parameters specified in the manual;<br />
*the supply conductors wire section is subject to the specifications for current density limit, insulation type and wire material. Light section can result in cable overheating and fire.<br />
When the power is on, NEVER:<br />
*connect/disconnect the connectors;<br />
*open modules and sensors.<br />
</div><br />
<br />
==Example of connection==<br />
<br />
[[File:BWACC EXA.png|500px]]<br />
<br />
==Module parameters==<br />
<br />
{{ Mp<br />
| uartqty = 1<br />
| power = 11.5 … 27.5 V DC from CAN<br />
| maxcur24v = 25 mA<br />
| bustype = CAN (4-wire)<br />
| instalation = Free<br />
| case = ABS<br />
| protection = IP40<br />
| temprange = -10 … +50 °C<br />
| size = 45x42x14 mm<br />
| weight = 15 g<br />
}}<br />
<br />
==Module installation and connection procedure==<br />
<br />
#Connect the interface connector.<br />
#Connect the CAN connector.<br />
#Configure the module using LT setup.<br />
#Check all equipment for proper operation.<br />
<br />
==Module shut-off and deinstallation procedure==<br />
<br />
#Disconnect the CAN connector.<br />
#Disconnect the interface connector.</div>FuzzyBot