FuzzyBot: Updating to match new version of source page

2022-01-09T13:15:33Z

Updating to match new version of source page

New page

<languages/>
{{RevisionChanger | hasA/B = 1 | hasC = 1}}
{{Infobox module
| name = BW-SW24V.C
| image = BW-SW24VC.png
| outCount = 6
| inCount = 6
| inB = 6
| inLB = 6
| voltage = 11.5...27.5 V DC
| dim = 45x42x14 mm
}}

==24V BUTTONS INPUT MODULE==

This module is used to connect 24V buttons w/wo LED backlighting.

==Example of connection==

[[File:SW24VC EXA1.png|500px]]
<br>
HW example:
<syntaxhighlight lang="xml" line>
hw="in='BBBBBB' out='BBBBBB' common='A'"
</syntaxhighlight>
6 common-wire buttons with common-anode 24 V DC LEDs
common='A' – use Out0 as common anode
[[File:SW24VC EXA2.png|500px]]
<br>
HW example:
<syntaxhighlight lang="xml" line>
hw="in='BBBBBB' out='BBBBBB' common='C'"
</syntaxhighlight>
6 common-wire buttons with common-catode 24 V DC LEDs
common='C' – use Out0 as common catode

==Module parameters==

{{ Mp
| outqty = 6
| inqty = 6
| buttons = 6
| ledbuttons = 6
| blvoltage = 11.5 … 27.5 V DC (from CAN)
| power = 11.5 … 27.5 V DC from CAN
| maxcur24v = 30 mA
| bustype = CAN (4-wire)
| instalation = Free
| case = ABS
| protection = IP40
| temprange = -10 … +50 °C
| size = 45x42x14 mm
| weight = 25 g
}}

==Module installation and connection procedure==

#Connect the inputs and outputs.
#Connect the CAN connector.
#Configure the module using LT setup.
#Check all equipment for proper operation.

==Module shut-off and deinstallation procedure==

#Disconnect the CAN connector.
#Disconnect the inputs and outputs..

==HW settings==
{|class="wikitable"
|-
!Name!!Type, range!!SUBID!!Default!!Description
|-
|in||char[6]||98||'BBBBBB'||Each char is responsible for the type of a particular channel
*'B'-Button, button of bell a type;
*'C'-Inverted button, inverse button of a bell type (for normally-closed);
*'-'-none, nothing is connected.
Example: in='BB-C-C'
|-
|out||char[6]||98||'BBBBBB'||Each char is responsible for the type of a particular channel
*'B'- LED of button;
*'I'- inverted LED of button;
*'L'- Lamp;
*'M'- inverted Lamp;
*'-'-none, nothing is connected.
Example: out='BBLILI'
|-
|common||char||98||'C'||LED common wire
*'C'- Use Out0 as common catode;
*'A'- Use Out0 as common anode;
Example: common='C'
|}

BW-SW24V/en - Revision history

FuzzyBot: Updating to match new version of source page