https://wiki.larnitech.com/index.php?action=history&feed=atom&title=Translations%3ALarnitech_Smart_Home_System_Architecture%2F1%2FenTranslations:Larnitech Smart Home System Architecture/1/en - Revision history2026-05-27T04:43:39ZRevision history for this page on the wikiMediaWiki 1.35.11https://wiki.larnitech.com/index.php?title=Translations:Larnitech_Smart_Home_System_Architecture/1/en&diff=7364&oldid=prevFuzzyBot: Importing a new version from external source2022-01-13T11:35:31Z<p>Importing a new version from external source</p>
<p><b>New page</b></p><div><youtube width="400px">x2LUHX0zOgY</youtube><br />
{| class="wikitable"<br />
|The Main Gateway is the core device of the system. Its main task is to configure the system, and provide the logic for<br />
its operation. It also keeps track of the sensors data and provides authorized access to the system. The Main Gateway is connected to the local network. It has 2 CAN bus ports.<br />
<br>[[file:Architecture1.png|700px]]<br />
|-<br />
|The CAN bus is used to connect the sensors and actuators to the system. Terminators, 120 Ohm resistors, need to be<br />
installed at the end of the CAN bus.<br />
<br>[[file:Architecture2.png|700px]]<br />
|-<br />
|As can be seen from the table below, a Four-wire bus is used (two twisted pairs) with a maximum length of a eight hundred<br />
metres. A maximum of 50 devices can be connected to each CAN bus.<br />
<br>[[file:Architecture3.jpg|700px]]<br />
|-<br />
|The following diagram shows how modules can be connected to the system. In the drawing below a 7-channel<br />
actuator, a leak control module and a heating control module have been connected to the first CAN bus.<br />
<br>[[file:Architecture4.png|700px]]<br />
|-<br />
|The second CAN bus has a four-in-one multi-sensor, a dimmer and a two-channel pattress box space actuator. In such</div>FuzzyBot