Valve-heating

Heating system valve type executor

Example of description in XML

1<item type="valve-heating" addr="100:48" name="Hall" temperature-sensors="119:10;119:11" automation="Cold" undefined-behavior="on" sensor-cr="348:35" sensor-cr-hi="30" sensor-cr-lo="10">
2<automation name="Hot" temperature-level="8" temperature-lag="0.2">
3<time-interval temperature-level="27" start-time="10:00" end-time="22:00" week-days="su;sa"/>
4<time-interval temperature-level="26" start-time="10:00" end-time="22:00" week-days="mo;tu;we;th;fr"/>
5</automation>
6<automation name="Cold" temperature-level="25" temperature-lag="0.7"/>
7</item>

Additional parameters

Name	type and variety	description	default value
temperature-sensors	list	list of valve temperature sensors (for automation)	-
automation	string	name of current automation mode	-
sub-type	enum	warm-floor	-
temperature-lag	number	hysteresis range on either side from set-point temperature Set in automation tag. The decimal symbol is dot.	0.5
undefined-behavior	enum on/off/last	valve position in case of sensors readings absence	last
sensor-cr	list	temperature-sensor measuring the maximum and minimum critical temperature	-
sensor-cr-hi	number	upper temperature limit, to disable warm floor in case of overheating	-
sensor-cr-lo	number	lower temperature limit, to activate the warm floor in case of overcooling.	-
t-min	number	lower temperature limit to set	0
t-max	number	upper temperature limit to set	32

Automation parameters (optional element)

Name	type and variety	description
name*	string	Device name in the control interface
temperature-level*	number	Temperature level for the intervals not specified in time-interval tags

* – required fields

Parameters of time-interval (optional element):

Name	type and variety	description
temperature-level*	Number	temperature level for this time interval
start-time*	HH:MM	interval starting time
end-time*	HH:MM	interval ending time
week-days	list mo;tu;we;th;fr;su;sa	list of week days when this interval is active

• – required fields

Device status as for event (1 byte)

Byte number	Description
0	Device status. 0 bit: 0 – zone is off 1 – zone is on 4-7 bits – number of current automation mode. Number is depending on order of automation description in logic.

Device status upon status request (6 bytes)

Byte	Description
0	Device status. 0 bit: 0 – zone is off 1 – zone is on 4-7 bits – number of current automation mode. Number is depending on order of automation description in logic.
1-2	Set-point temperature, low-high bytes
3-4	Middle temperature of connected sensors, low-high bytes
5	254 – "Always off" mode 255 – "Manual" mode

Possible variants of setting the status

Byte	Description
0	0 – off 1 – on 0xFF – Change the status for the opposite one