Changes

Created page with "#Install the module in the switchboard on the DIN-rail and fix it with the special latch on the module base. #Fasten the supply unit on the left side of the module. #Connect t..."
#Install the module in the switchboard on the DIN-rail and fix it with the special latch on the module base.
#Fasten the supply unit on the left side of the module.
#Connect the connector (4) having the noise filter pre-installed which is supplied complete with the module.
#Connect the connectors (5), (6).
#Connect the connectors (1), (2).
#Connect the connector (3).
#Apply power to the supply unit of METAFORSA module.
#Wait until the module is loaded, then configure it in accordance with the '''System Setup Instructions.'''
#Apply power to the connectors (1), (2).
#Check all equipment for proper operation.
editor, Interface administrators, Administrators, translation-admin, translator
9,750

edits