Changes

Jump to navigation Jump to search
Created page with "{{ConExC |Oprez: Pre nego što primenite napajanje na modul, morate pravilno da konfigurišete izlaze u aplikaciji. Netačno konfigurisani kontakti mogu dovesti do istovremeno..."
Line 377: Line 377:     
{{ConExC
 
{{ConExC
|Caution: Before applying power to the module, you must properly configure the outputs in the application. The contacts configured incorrectly can lead to simultaneous power supply to both channels, resulting in the module failure and/or failure of the equipment connected to it, and even a fire.
+
|Oprez: Pre nego što primenite napajanje na modul, morate pravilno da konfigurišete izlaze u aplikaciji. Netačno konfigurisani kontakti mogu dovesti do istovremenog napajanja oba kanala, što rezultira kvarom modula i/ili kvarom opreme koja je na njega povezana, pa čak i požarom.
|Pjalousie|Fig. 9|Two adjacent contact points (for example, 3, 4) should be used to connect the curtain/jalousie/rolladens actuator, in these conditions the neutral wire and the ground wire are connected directly to the switchboard. The example of connection is shown in '''Fig.9.'''
+
|Pjalousie|Sl. 9|Dve susedne kontaktne tačke (na primer, 3, 4) treba da se koriste za povezivanje aktuatora zavese/žaluzije/roladensa, u ovim uslovima neutralna žica i žica za uzemljenje su spojene direktno na centralu. Primer povezivanja je prikazan na '''Sl. 9'''.
 
}}
 
}}
  
editor, Interface administrators, Administrators, translation-admin, translator
9,750

edits

Navigation menu