Difference between revisions of "Translations:Metaforsa 3/3.plus/69/sr"

From Larnitech wiki page
Jump to navigation Jump to search
(Created page with "#Ugradite modul u centralu na DIN šinu i pričvrstite ga specijalnom rezom na bazi modula. #Pričvrstite jedinicu za napajanje na levoj strani modula. #Priključite konektor...")
Tags: Mobile web edit Mobile edit
 
(No difference)

Latest revision as of 14:26, 8 April 2024

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Metaforsa 3/3.plus)
#Install the module in the switchboard on the DIN-rail and fix it with the special latch on the module base.
#Fasten the supply unit on the left side of the module.
#Connect the connector (4) having the noise filter pre-installed which is supplied complete with the module.
#Connect the connectors (5), (6).
#Connect the connectors (1), (2).
#Connect the connector (3).
#Apply power to the supply unit of METAFORSA module.
#Wait until the module is loaded, then configure it in accordance with the '''System Setup Instructions.'''
#Apply power to the connectors (1), (2).
#Check all equipment for proper operation.
Translation#Ugradite modul u centralu na DIN šinu i pričvrstite ga specijalnom rezom na bazi modula.
#Pričvrstite jedinicu za napajanje na levoj strani modula.
#Priključite konektor (4) sa unapred instaliranim filterom za buku koji se isporučuje zajedno sa modulom.
#Priključite konektore (5), (6).
#Priključite konektore (1), (2).
#Priključite konektor (3).
#Uključite napajanje na jedinicu napajanja METAFORSA modula.
#Sačekajte dok se modul ne učita, a zatim ga konfigurišite u skladu sa '''Uputstvima za podešavanje sistema'''.
#Uključite napajanje na konektore (1), (2).
#Proverite da li sva oprema radi ispravno.
  1. Ugradite modul u centralu na DIN šinu i pričvrstite ga specijalnom rezom na bazi modula.
  2. Pričvrstite jedinicu za napajanje na levoj strani modula.
  3. Priključite konektor (4) sa unapred instaliranim filterom za buku koji se isporučuje zajedno sa modulom.
  4. Priključite konektore (5), (6).
  5. Priključite konektore (1), (2).
  6. Priključite konektor (3).
  7. Uključite napajanje na jedinicu napajanja METAFORSA modula.
  8. Sačekajte dok se modul ne učita, a zatim ga konfigurišite u skladu sa Uputstvima za podešavanje sistema.
  9. Uključite napajanje na konektore (1), (2).
  10. Proverite da li sva oprema radi ispravno.