Changes
Jump to navigation
Jump to search
181 bytes removed
, 17 April
mLine 5: |
Line 5: |
| | image = LED-AMP.png | | | image = LED-AMP.png |
| | outCount = 4 | | | outCount = 4 |
− | | peakl = ? | + | | peakl = 3A |
− | | voltage = ? V DC | + | | voltage = 12..24 V DC |
− | | dim = ? mm | + | | dim = 65x18x15 mm |
| }} | | }} |
| | | |
Line 35: |
Line 35: |
| | | |
| <!--T:6--> | | <!--T:6--> |
− | [[File:LED-AMP_connection_scheme.png|800px]] | + | [[File:LED-AMP_connection_scheme.png|600px]] |
| | | |
− | ==RGB connection scheme== <!--T:7--> | + | ==Module parameters== <!--T:7--> |
| | | |
| <!--T:8--> | | <!--T:8--> |
− | <div class="caution">CAUTION! Output channels should only be connected using amplifier which uses 5V PWM signal from IO output as input</div>
| |
− | [[File:IOC_RGB_EX.png|600px]]
| |
− |
| |
− |
| |
− | ==Module parameters== <!--T:9-->
| |
− |
| |
− | <!--T:10-->
| |
| {{ Mp | | {{ Mp |
| | outqty = 4 | | | outqty = 4 |
Line 52: |
Line 45: |
| | currtype = DC | | | currtype = DC |
| | adjtype = PWM | | | adjtype = PWM |
− | | maxperch = ? | + | | maxperch = 3A |
| | power = 11.5 … 27.5 V DC | | | power = 11.5 … 27.5 V DC |
| | instalation = Free | | | instalation = Free |
Line 58: |
Line 51: |
| | protection = IP40 | | | protection = IP40 |
| | temprange = -10 … +50 °C | | | temprange = -10 … +50 °C |
− | | size = ? mm | + | | size = 65x18x15 mm |
− | | weight = ? g | + | | weight = 25 g |
| }} | | }} |
| | | |
− | ==Module installation and connection procedure== <!--T:11--> | + | ==Module installation and connection procedure== <!--T:9--> |
| | | |
− | <!--T:12--> | + | <!--T:10--> |
− | #Connect the outputs. | + | #Connect the inputs and outputs. |
− | #Configure the module using LT setup. | + | #Configure the module using LT Setup. |
| #Apply power to the load. | | #Apply power to the load. |
| #Check all equipment for proper operation. | | #Check all equipment for proper operation. |
| | | |
− | ==Module shut-off and deinstallation procedure== <!--T:13--> | + | ==Module shut-off and deinstallation procedure== <!--T:11--> |
| | | |
− | <!--T:14--> | + | <!--T:12--> |
| #Disconnect the power from the load. | | #Disconnect the power from the load. |
− | #Disconnect the outputs. | + | #Disconnect the inputs and outputs. |