3,388
edits
Changes
Jump to navigation
Jump to search
Translations:Metaforsa MF-10/74/en (view source)
Revision as of 14:57, 2 January 2022
, 14:57, 2 January 2022Importing a new version from external source
#Install the module in the switchboard on the DIN-rail and fix it with the special latch on the module base.
#Fasten the supply unit on the left side of the module.
#Connect the connector (8) having the noise filter pre-installed which is supplied complete with the module.
#Connect the connectors (9) – (14).
#Connect the connectors (1) – (5).
#Connect the connector (7).
#Apply power to the supply unit of METAFORSA module.
#Wait until the module is loaded, then configure it in accordance with the '''System Setup Instructions'''.
#Apply power to the connectors (1), (3), (5).
#Check all equipment for proper operation.
#Fasten the supply unit on the left side of the module.
#Connect the connector (8) having the noise filter pre-installed which is supplied complete with the module.
#Connect the connectors (9) – (14).
#Connect the connectors (1) – (5).
#Connect the connector (7).
#Apply power to the supply unit of METAFORSA module.
#Wait until the module is loaded, then configure it in accordance with the '''System Setup Instructions'''.
#Apply power to the connectors (1), (3), (5).
#Check all equipment for proper operation.