Climate control settings/en

1. Open LT Setup, in General tab click on Climate control

2. Click on +Add button

3. In the pop-up window, fill the fields below, Save changes

• Name - any you like
• Module - device, that will be controlling the climate
• Location - the room, in which your climate will be situated
  

4. In the new window, you will set settings for the climate.
In the Sensors panel, choose sensors from drop-down list for Temperature/Humidity/Warm floor/CO2.
If you don`t have Humidity or CO2 sensors, for example, leave the fields empty.

5. When you choose one, click on+, to add it !!

6. After this, you will see the added sensor.
If you won`t add a sensor like this, you can`t add devices (radiators, etc) to work with it.
For Humidity/Warm floor/CO2 tabs procedure the same. You can use one sensor for some tabs.

7. After the Sensors tab, move to Automation settings.
There you can add devices to any Automation mode (Eco, Comfort, Hot) or create new ones.

8. Click on +Add device, choose your object and Save settings.

9. After Save, your device will appear below the tab Temperature. You can add as many devices as you have.

10. For the next tabs and modes, identic procedure.

11. To use a warm floor, you need to change the sub-type of Radiator. It`s available from the app.
Open Larnitech app, find an object that you wants to control the warm floor, turn on Edit mode, make a long press and then click on Edit item.
In the Advanced tab, change the type of the device, and save changes.

12. Green asterisk - shows the mode, that you choosed for. You can change it in the app.

13. All added objects for climate control, will appear below the main widget.

14. Launch the object, all added devices should turn on.
If some object doesn`t turn on, check the settings of modes (Eco, Comfort, Hot) in LT setup - added device accordings to each type of heat/cool, warm floor, etc.