IRidium

<nav style="width:1000px;">

1. Authorize yourself in the Web Toolbar of the Smart Home system administration (LT Setup) and go to the Updates page.
   
   
2. In the list of updates, find iRidium and click the Update button (if the plug-in is not installed, there will be the Install button – click it).
   
   
3. Read the warning, tick the box next to “I agree” inscription and click the Start update button.
   
   
4. When the update is complete, select the Plugins page of the General section in the left menu.
   
   
5. Find API in the list and click Configure.
   
   
6. Note the value in the Port field. If it is equal to 8888, you need to change it, since the iRidium server uses it. Enter the desired value; click Save at the bottom of the screen and OK in the next window.
   
   
   
   
7. Go back to the Plugins page, find iRidium in the list and click Configure.
   
   
   
   
8. In the window that appears, you can install iRidium. To do this, select the required version (Pro or Lite) in the Server version field, and then click Install.
   
   
9. A window will appear asking you to change the API port address if its value is 8888 – these actions are described in steps 4, 5 and 6. If you have changed the address, click OK.
   
   
10. A window with the “Installing” inscription will appear on the screen, and then a window with a message about the successful installation.
    
    
    
    
11. Now, the iRidium server control panel will appear in the Configure menu.
    
    The Server enabled/Server disabled button is marked 1. The Restart server button is marked 2. A message with the installed version of the server is located under the control buttons. If you want to install another version, select it in the field marked 3 and click Install (marked 4).
</nav>