Changes

|stop||Char ‘R’||1-12||–||(for 2-pole gate and blinds) If it is declared then by Stop command during the motion, the same impulse appears as it was at the beginning of the motion. Pole, an which the stop-impules is formed, is defined by the parameter Stop value. If it is ‘r’ or ‘R’ then stop-impulse is produced on the opposite to the start-impulse pole. If any other value is delcared (e.g., ‘d’ ) then the stop-impulse is on the same pole. If a Runtime passed after the beginning of the motion then the stop-impulse is not formed. Example: stop=’r’

|stop||Char ‘R’||1-12||–||(for 2-pole gate and blinds) If it is declared then by Stop command during the motion, the same impulse appears as it was at the beginning of the motion. Pole, an which the stop-impules is formed, is defined by the parameter Stop value. If it is ‘r’ or ‘R’ then stop-impulse is produced on the opposite to the start-impulse pole. If any other value is delcared (e.g., ‘d’ ) then the stop-impulse is on the same pole. If a Runtime passed after the beginning of the motion then the stop-impulse is not formed. Example: stop=’r’

|-

|-

|out||char[7]||98||'LLLLLLL'||Each char is responsible for the type of a particular channel

|out||char[12]||98||'LLLLLLLLLLLL'||Each char is responsible for the type of a particular channel

*'L'-Lamp;

*'L'-Lamp;

*'M'-Lamp Inverse;

*'M'-Lamp Inverse;

For example, offset is -3.8 : hw="offset='-3.8'"

For example, offset is -3.8 : hw="offset='-3.8'"

|-

|-

|in||char[12]||98||'KKKKKKKKKKKK'||Each char is responsible for the type of a particular channel

|in||char[24]||98||'KKKKKKKKKKKKKKKKKKKKKKKK'||Each char is responsible for the type of a particular channel

*'B'-Button;

*'B'-Button;

*'C'-Inverted button;

*'C'-Inverted button;