3,388
edits
Changes
Importing a new version from external source
==Module installation and connection procedure==
#Install the module in the switchboard on the DIN rail and fix it with the special latch on the module base.
#Connect the UART connector.
#Connect the CAN connector.
#Configure the module using LT setup.
#Check all equipment for proper operation.
#Install the module in the switchboard on the DIN rail and fix it with the special latch on the module base.
#Connect the UART connector.
#Connect the CAN connector.
#Configure the module using LT setup.
#Check all equipment for proper operation.