Larnitech wiki page

Translations:DW-DALI2.C/DW-DALI.C/20/en

Module installation and connection procedure

CAUTION! You must precisely follow the recommendations listed in the «Safety Requirements» section of this manual.

  1. Install the module in the switchboard on the DIN-rail and secure it with special latches available on the module base.
  2. Connect the CAN-bus (4).
  3. Connect the DALI-bus (1).
  4. Connect the DALI power connector (2).
  5. Energise the module power supply (24 V).
Retrieved from "https://wiki.larnitech.com/index.php?title=Translations:DW-DALI2.C/DW-DALI.C/20/en&oldid=5839"