Translations:Metaforsa 3/3.plus/94/en

• 'e' - led-button inverse
• 'd' - led-button
• 'c' - button inverse
• 'b' - button
• 's' - switch
• 'k' - contact inverse
• 'h' - contact
• 'l' - leak
• 'n' - Neptun
• 'v' - motion inverse
• 'm' - motion
• 'r' - thermo-resistor
• 't' - DALLAS
• '-' - none

Example: io='KKKKKKKKKKKKKKKKKKKKKKKKKKKK' |- |hw||string||98||-||hw="...", where

• pwm_invert – PWM inverting [1, 0];
• lbn_bright – brightness of led buttons, range (0 - 255);
• f – by default PWM frequency is 1000, range (1 - 5000).

Example:

1hw="io='4---zdd----t--' pwm_invert=1 lbn_bright=255 f=1000"

|- |colspan="3"|Only for Metaforsa 3.plus |- |cfg||string||98||9600/8N1||cfg='SPEED/BPS', where

• SPEED – baud rate [1200..115200];
• B – data length [7,8];
• P – presence and type of parity bit [N(No parity),E(Even parity),O(Odd parity)];
• S – stop bit length [1, 1.5 or 2].

Example:

1hw="cfg='9600/8N1'"

|- |[Protocol]||string||98||—||Protocol setting is described by protocol parameter. The following protocols are supported:

• 'modbus', Modbus protocol, at the end of redirection the checksum CRC16(Modbus) is added;
• 'dmx', DMX protocol;
• 'CO2' for connecting Larnitech CO2 sensors;
• 'salda' for connecting Salda ventilation.

Example:

1hw="cfg='9600/8N1' modbus"

|- |echo||on; off||98||'off'||For settings check out and testing echo parameter can be used. Module echo-reply can be turned on or off with the help of this parameter.Echo parameter value:

• 'off'
• 'on'

Example:

1hw="cfg='9600/8N1' echo='off'"

|}