Changes

The nominal value of the circuit breaker should be calculated based on the maximum total load of connected

The nominal value of the circuit breaker should be calculated based on the maximum total load of connected

devices and at the same time should not significantly exceed the maximum permissible characteristics of the actuator.

devices and at the same time should not significantly exceed the maximum permissible characteristics of the actuator.

Depending on the requirements, you can use one circuit breaker for one actuator (it is recommended)

Depending on the requirements, you can use one circuit breaker for one actuator (it is recommended, see Fig. 1)

or one circuit breaker per each group of connected loads, or, if necessary, a separate circuit breaker can be installed

or one circuit breaker per each group of connected loads (see Fig. 2), or, if necessary, a separate circuit breaker can be installed

for each load.

for each load (see Fig. 3)<br>

[[File:LC07Aexa1.png|500px]]

==Connection of actuators==

==Connection of actuators==