1,970
edits
Changes
Jump to navigation
Jump to search
Line 11:
Line 11: − + Line 87:
Line 87: − + Line 94:
Line 94: − + Line 136:
Line 136: + + + + + + + + + + +
→RS485/MBUS INTERFACE ADAPTER
==RS485/MBUS INTERFACE ADAPTER==
==RS485/MBUS INTERFACE ADAPTER==
This module is designed for interface adjustment between the devices which have the RS485 interface and the Smart Home system. This module has an internal 120Ω terminator resistor.
This module is designed for reading data from electricity (RS485), water, gas, heat (M-BUS) meters
==Features==
==Features==
==Module installation and connection procedure==
==Module installation and connection procedure==
#Install the module in the switchboard on the DIN rail and fix it with the special latch on the module base.
#Install the module in the switchboard on the DIN rail and fix it with the special latch on the module base.
#Connect the X1 connector.
#Connect the RS485 and MBUS connector.
#Connect the CAN connector.
#Connect the CAN connector.
#Configure the module using LT setup.
#Configure the module using LT setup.
==Module shut-off and deinstallation procedure==
==Module shut-off and deinstallation procedure==
#Disconnect the CAN connector.
#Disconnect the CAN connector.
#Disconnect the X1 connector.
#Disconnect the MBUS and RS485 connector.
#Remove the module from the DIN rail, releasing the latch at the bottom of the module base.
#Remove the module from the DIN rail, releasing the latch at the bottom of the module base.
<syntaxhighlight lang="xml" line>
<syntaxhighlight lang="xml" line>
hw="cfg='9600/8N1' term=1"
hw="cfg='9600/8N1' term=1"
</syntaxhighlight>
|-
|mbus|| params ||2|| - || Sets the polled counters on the MBUS
mbus='<address1>:<mask1>:<period1> <address2>:<mask2>:<period2>'<br>
where:
*<addressX> - counter address on the bus
*<maskX> - The bit mask specifies which parameters of this counter will be included in the report and will be sent by the module to the server. Here the lowest bit specifies the presence of general information in the report, and the remaining 31 bits correspond to parameters from "0" to "30". This field can be skipped. By default, it is 0xFFFFFFFFFFFF
*<period2> - the polling period for this counter in minutes. This field can be skipped. The default value is 15. The range of possible values is from 10 to 1440
Example:
<syntaxhighlight lang="xml" line>
<item addr="326:2" cfgid="135" hw="mbus='1:0xFFEC:20'" name="MBUS" type="com-port"/>
</syntaxhighlight>
</syntaxhighlight>
|}
|}