Changes

 

Reset to factory defaults

Reset to factory defaults

If you need to reset your DE-MG/Metaforsa device to factory defaults, you can do this using the web panel of Smart Home administration (LT Setup) or using the button on the DE-MG or Metaforsa module.

If you need to reset your DE-MG/Metaforsa device to factory defaults, you can do this using the web panel of Smart Home administration (LT Setup) or using the button on the DE-MG or Metaforsa module.

==WARNING!== For a successful reset, your module must have the latest firmware version.

==WARNING!== For a successful reset, your module must have the latest firmware version.

==Updating Firmware of DE-MG or Metaforsa Module==

==Updating Firmware of DE-MG or Metaforsa Module== <!--T:1-->

1. In the menu on the left, select “Modules” (the “General” category).

1. In the menu on the left, select “Modules” (the “General” category).

<br>[[file:reset1.png|300px]]<br>

<br>[[file:reset1.png|300px]]<br>

2b. In Metaforsa modules, the button is located under the case cover. Its location is shown in the photo below; you need to press it with a thin object through the hole.

2b. In Metaforsa modules, the button is located under the case cover. Its location is shown in the photo below; you need to press it with a thin object through the hole.

<br>[[file:reset15.png|500px]]<br>

<br>[[file:reset15.png|500px]]<br>

3. While holding the “Recovery” button down, plug in the power connector.

3. While holding the “Recovery” button down, plug in the power connector.

On DE-MG modules, the indicator (designated as 4 in the diagram above) should light up in blue, and then start flashing red. When the LED stops flashing and turns red, release the button. The reset process has started. It can take from 15 to 40 minutes, and during this time period the color of the indicator may change. When the reset process is completed, the indicator will turn green.  

On DE-MG modules, the indicator (designated as 4 in the diagram above) should light up in blue, and then start flashing red. When the LED stops flashing and turns red, release the button. The reset process has started. It can take from 15 to 40 minutes, and during this time period the color of the indicator may change. When the reset process is completed, the indicator will turn green.  

To start the LT Setup web panel, see the Instructions for Running LT Setup.

To start the LT Setup web panel, see the Instructions for Running LT Setup.