Satel integration

Revision as of 14:00, 23 November 2021 by Erich (talk | contribs) (Created page with "Security - SATEL installation & configuration ==SATEL Keypad - Preparing to integration== #Connect ethernet cable to your TCP module. #Enter the service code (by default 12345...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Security - SATEL installation & configuration

SATEL Keypad - Preparing to integration

  1. Connect ethernet cable to your TCP module.
  2. Enter the service code (by default 12345) and press [*].
  3. Select the item SERVICE MODE from the list and press the [#] or [X] key.
  4. Select Configuration from the list and press the [#] or [X] key.
  5. Select INTEGRA Ident.
  6. Write down the code and repeat the same for DloadX Ident. and GuadX Ident.
  7. Exit from Configuration page, and Select Structure page/Modules/LCD-Keypads/Setup/
  8. Select your TCP module from the list and press the [#] or [X] key.
  9. Select Key (DloadX)
  10. Write down the code

SATEL - DloadX

  1. When the program starts, it will ask you to enter a password. Default password 1234
  2. Select Communication/Connection Settings page

     

  3. Fill in the fields similar to the screenshot below. Use identifiers obtained from the panel, IP address of your SATEL module.

     

  4. Select Connection/ TCP/IP: DLOADX -> ETHM (You can use different options for connection). Click ‘Connect’
    Connection error log example:
    Connecting to server: 192.168.1.223:7090 Establishing connection Module: ETHM-1 V2.07 Wrong panel identifier - Wrong INTEGRA Ident. Hanged up. Connecting to server: 192.168.1.223:7090 Establishing connection Module: ETHM-1 V2.07 Wrong PC identifier - Wrong DLOADX Ident. or GUARDX Ident. Hanged up.
  5. You can find your connection settings there after reading data from the TCP module. Check that you have similar settings.

     



     



      

  6. Example of configuration default NO - normally open reed switch


Open Structure settings



 


Create Partition



 

Create zone/device



 


Larnitech Security Plugin configuration:

  1. Make sure you have SATEL licenses

     

  2. Make sure you have the latest versions of LT Setup, LT Server, Security plugin installed

     

  3. Configure plugin and enable.

     

  4. Select the Satel page, fill in the fields similar to the screenshot below and enable the integration

     

    IP: Your Satel TCP module Port: Integration port. Default: 7094 c



How does integration work?

Our plugin is just a receiver for Satel data, we send only a couple commands like Reset alarms, pin, arm and disarm. But the logic of these commands are processed by Satel.