Настройки плагина безопасности

Revision as of 12:46, 15 January 2022 by Rusanov (talk | contribs) (Created page with "Настройки плагина безопасности")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Other languages:
English • ‎русский

1. Open LT Setup, General tab, click on Plugins
Screenshot 1.png
2. Find Security plugin, click on Enable button to launch it
02.png
3. Then click on Configure button 03.png
4. Click on +Add zone, to set actions for alarm settings
04.png
5. Zone name - any you like, but to understand what system/sensors you will use
05.png
6. You can add different zones. All added scenarios will appear below
06.png
7. Then click on +Add device button, to add responsible sensors for the action
07.png
8. In pop-up window set sensor and settings for it and save changes

  • Device type - set Arm
  • Device - choose you sensor
  • Name - sensors name in security plugin
  • Recovery timeout - time in seconds, when sensor resets after an alarm is triggered, until the problem disappears (door closing, no movement)
  • Level for alarm - range of values 1-100 for motion sensors

08.png
9. To watch, what the sensor is responsible for action, click on the folder. You can add some sensors into a zone
For all other zones, identic procedure
09.png
10. After settings of zones, you need to add at least one user, create a password, and set the permissions for the user
Click on the Users tab, and then on +Add
10.png
11. In pop-up window, made a settings for the user, and save changes
11.png 12.png
12. After the creation of the user, the Security plugin becomes available in-app
Open the app, click on the wi-fi icon, then on the Security icon. Will open the window with pin code confirmation
Enter the pin you created for user, and then Ok
13.png 14.png
13. In Home tab, you will see your zones, and after clicking on the right corner icon, the sensors that you set
15.png
14. In Security tab, you will see the widget
16.png

  • ARM - full arming of the house with your zones

17.png

  • Partial ARM - you can choose one or some zones for arming

18.png

  • Disarm - disarming the house

19.png

  • Armed - house under protection

20.png

  • Alarm - when sensors are triggering, the widget will turn Red and push-notification sent to your phone

21.png 22.png

  • To reset the sensors, click on Alarm button, Reset sensors and Ok

23.png
15. Also, you can set the scenarios for the Partial arm. For that, you need to go settings of the Security plugin
On your zone, click on +Add device
24.png
16. In pop-up window, click on Device type - in drop-down list choose Arm
New fields will be appears
25.png
17. Click on +Add mode. In the new window, set any name you like, Save settings and your mode will appear below
26.png
18. After that, you can set the mode for your zones. For example day/night, and Save settings
27.png
19. Open app, enter in Security plugin, move to Partial arm
Your modes will appear in the drop-down list
28.png
20. Click on the mode you want to arm and then Ok. The system will be activated
29.png
21. To see, what zones are actually enabled, click on the Home tab
30.png
22. Do the same with another mode - Night, in our case. And your settings will be activated
31.png
23. Check the settings in Home tab
32.png