Changes

17 bytes removed ,  13:31, 16 November 2021
Line 42: Line 42:     
==Switch-two-phys-btn==
 
==Switch-two-phys-btn==
 +
This type of configuration is used if you have physically 2 buttons on a panel, one of which always sends the command on (1) and the second off (0). In this case, 2 buttons are created in the Larnitech system, each of which can be used independently.
 +
Most of the panels do not allow independent use of the feedback LEDs, therefore, if the keys are used independently, the indication may not work correctly.
    
===Button configuration in ETS:===
 
===Button configuration in ETS:===
Line 56: Line 58:  
  From EIB (BAOS, chID 0, seq_cntr 0) => source 15/15/255 destination 2/0/3 data len 1: 00  - '''Feedback 2 sent'''
 
  From EIB (BAOS, chID 0, seq_cntr 0) => source 15/15/255 destination 2/0/3 data len 1: 00  - '''Feedback 2 sent'''
 
  From EIB (BAOS, chID 0, seq_cntr 0) => source 15/15/255 destination 2/0/0 data len 1: 00  - '''Feedback sent'''
 
  From EIB (BAOS, chID 0, seq_cntr 0) => source 15/15/255 destination 2/0/0 data len 1: 00  - '''Feedback sent'''
  −
===Comment:===
  −
This type of configuration is used if you have physically 2 buttons on a panel, one of which always sends the command on (1) and the second off (0). In this case, 2 buttons are created in the Larnitech system, each of which can be used independently.
  −
Most of the panels do not allow independent use of the feedback LEDs, therefore, if the keys are used independently, the indication may not work correctly.
  −
      
==Switch-long-press==
 
==Switch-long-press==