Changes

18 bytes removed ,  13:33, 16 November 2021
Line 114: Line 114:     
==Climate Control==
 
==Climate Control==
 +
Heat/Cool Setpoint - Must be selected if the thermostat panel has only 1 address for two setpoints. In this case, depending on the selected mode in the climate control, the following values will be taken:
 +
*If climate control is in heating mode, Heat/Cool setpoint will be accepted as the heating setpoint. Likewise within the Cooling mode, Heat/Cool setpoint will be accepted as the cooling setpoint.
 +
*If the climate control is in the Heating/Cooling mode, it will use add/subtract delta  and set 2 setpoints (Heat and cool). For example setpoint 25 will be transformed to 23-27.
    
===Thermostat configuration in ETS:===
 
===Thermostat configuration in ETS:===
Line 138: Line 141:  
  From EIB (BAOS, chID 0, seq_cntr 0) => source 15/15/255 destination 4/0/2 data len 3: 00 0c e2 - '''Setpoint sent to the thermostat'''
 
  From EIB (BAOS, chID 0, seq_cntr 0) => source 15/15/255 destination 4/0/2 data len 3: 00 0c e2 - '''Setpoint sent to the thermostat'''
 
  From EIB (BAOS, chID 0, seq_cntr 0) => source 1/1/1 destination 4/0/1 data len 3: 00 0c e2 - '''Setpoint received'''
 
  From EIB (BAOS, chID 0, seq_cntr 0) => source 1/1/1 destination 4/0/1 data len 3: 00 0c e2 - '''Setpoint received'''
  −
===Comment:===
  −
  −
Heat/Cool Setpoint - Must be selected if the thermostat panel has only 1 address for two setpoints. In this case, depending on the selected mode in the climate control, the following values will be taken:
  −
*If climate control is in heating mode, Heat/Cool setpoint will be accepted as the heating setpoint. Likewise within the Cooling mode, Heat/Cool setpoint will be accepted as the cooling setpoint.
  −
*If the climate control is in the Heating/Cooling mode, it will use add/subtract delta  and set 2 setpoints (Heat and cool). For example setpoint 25 will be transformed to 23-27.
  −
      
==Air Conditioner==
 
==Air Conditioner==