editor, Interface administrators, Administrators, translation-admin, translator
9,750
edits
Changes
Jump to navigation
Jump to search
m
Add RGB connection scheme
Line 37:
Line 37:
+
+
+
[[File:LED-AMP_connection_scheme.png|800px]]
[[File:LED-AMP_connection_scheme.png|800px]]
−==Module parameters== <!--T:7-->
+==RGB connection scheme== <!--T:7-->
+<!--T:8-->
+<div class="caution">CAUTION! Output channels should only be connected using amplifier which uses 5V PWM signal from IO output as input</div>
+[[File:IOC_RGB_EX.png|600px]]
+==Module parameters== <!--T:9-->
<!--T:10-->
<!--T:10-->
Line 55:
Line 62:
}}
}}
−==Module installation and connection procedure== <!--T:8-->
+==Module installation and connection procedure== <!--T:11-->
−<!--T:9-->
+<!--T:12-->
#Connect the outputs.
#Connect the outputs.
#Configure the module using LT setup.
#Configure the module using LT setup.
Line 63:
Line 70:
#Check all equipment for proper operation.
#Check all equipment for proper operation.
−==Module shut-off and deinstallation procedure== <!--T:10-->
+==Module shut-off and deinstallation procedure== <!--T:13-->
−<!--T:11-->
+<!--T:14-->
#Disconnect the power from the load.
#Disconnect the power from the load.
#Disconnect the outputs.
#Disconnect the outputs.