1,970
edits
Changes
Jump to navigation
Jump to search
→METAFORSA module shut-off and deinstallation procedure
Line 487:
Line 487:
#Disconnect the connectors (8)-(14).
#Disconnect the connectors (8)-(14).
#Remove the module from the DIN-rail, releasing the latch at the bottom of the module base.
#Remove the module from the DIN-rail, releasing the latch at the bottom of the module base.
+
+==Hardware setup==
+
+To configure and control METAFORSA SMART HOUSE, you must install Larnitech software on your smartphone or tablet, which is available in [https://itunes.apple.com/us/app/larnitech/id1108457530?mt=8 App Store] and [https://play.google.com/store/apps/details?id=com.larnitech Play Market]. After installation, follow the '''System Setup Instructions'''.
+
+==Fault diagnostics and handling==
+
+The following are some possible faults and ways of fault handling. If you have any difficulty, or face the fault undeclared here, please contact the Technical Support: [http://www.larnitech.com/support/] or [support@larnitech.com].
+There are also some tips in the FAQ section at our website [http://www.larnitech.com/faq/].
+
+===The actuators do not operate:===
+
+*ensure the outputs are properly configured in the application (see '''System Setup Instructions''');
+*check the connection is correct in accordance with '''table 2 and''' paragraph 3.6;
+*ensure the power is supplied to the input power contact , i.e. all circuit breaker assembly are ON.
+*verify the operability of the connected equipment.
+
+===The module is off, indication absent:===
+
+*check the connection to 24V supply unit as shown in '''table 2''' (contacts pin assignment);
+*check the connection of the supply unit to 220V power mains, the indicator should be ON.
+
+===Network connection fault:===
+
+*ensure the Ethernet cable is properly wired and connected to the connector;
+*ensure the LED status indicators are ON on the Ethernet connector;
+*check the LAN configuration is correct, Ethernet cable loops are absent;
+*METAFORSA module and the device you are connecting from are in the same network.
+
+hold integer 0-10000 1-10 by default hold is the same as runtime
+hold is the bridging time in miliseconds, is used for gate and jalousie, lock; Example: hold=3500
+
+
+===The sensors do not operate:===
+
+*ensure the inputs are properly configured in the application ('''System Setup Instructions''');
+*check the connection is correct in accordance with '''table 2''' and paragraph 3.7;
+*ensure the METAFORSA module is ON: circuit breaker assembly is closed, indication on the supply unit is ON, the module indication corresponds to the operating status – '''table 3''';
+*check the power supply availability on the sensors;
+*check the integrity of lines laid to the sensors.
+
+===The auxiliary equipment does not operate:===
+
+*check the connection is correct in accordance with table 2 and paragraph 3.8-9;
+*ensure the METAFORSA module is ON: circuit breaker assembly is closed, indication on the supply unit is ON, the module indication corresponds to the operating status – table 3;
+*check the integrity of the CAN lines, voltage supply on the modules.