Changes
Jump to navigation
Jump to search
479 bytes added
, 15:09, 29 January 2022
Line 18: |
Line 18: |
| ==МОДУЛЬ АВТОМАТИЧЕСКОГО СЧИТЫВАНИЯ ПОКАЗАНИЙ СЧЕТЧИКА== | | ==МОДУЛЬ АВТОМАТИЧЕСКОГО СЧИТЫВАНИЯ ПОКАЗАНИЙ СЧЕТЧИКА== |
| | | |
− | Модуль предназначен только для системы диспетчеризации. Он не используется в основной системе Larnitech Smart Home. | + | Модуль предназначен только для системы диспетчеризации. Он не используется в основной системе для Умного дома Larnitech. |
| | | |
| <div class="caution"> | | <div class="caution"> |
Line 35: |
Line 35: |
| </div> | | </div> |
| | | |
− | ==Overview== | + | ==Изображение модуля== |
| | | |
| [[File:DISPATCH VIEW.jpg|500px]] | | [[File:DISPATCH VIEW.jpg|500px]] |
| | | |
− | ==Module dimensions== | + | ==Размеры модуля== |
| | | |
| [[File:DISPATCH DIM.png|500px]] | | [[File:DISPATCH DIM.png|500px]] |
| | | |
− | ==Example of connection== | + | ==Пример подключения== |
| | | |
| [[File:DISPATCH EXA.jpg|500px]] | | [[File:DISPATCH EXA.jpg|500px]] |
| | | |
− | ==Module parameters== | + | ==Параметры модуля== |
| | | |
| {{ Mp | | {{ Mp |
Line 65: |
Line 65: |
| }} | | }} |
| | | |
− | ==Indication of module operation== | + | ==Индикация работы модуля== |
| {{indicationold}} | | {{indicationold}} |
| | | |
− | ==Module installation and connection procedure== | + | ==Порядок установки и подключения модуля== |
− | #Install the module in the switchboard on the DIN rail and fix it with the special latch on the module base. | + | #Установите модуль в распределительный щит на DIN-рейку и закрепите специальной защелкой, расположенной на основании модуля. |
− | #Connect the X1-X4 connectors. | + | #Подсоедините разъемы X1-X4. |
− | #Connect the CAN connector. | + | #Подключите разъем CAN. |
− | #Configure the module using LT setup. | + | #Настройте модуль с помощью LT SETUP. |
− | #Check all equipment for proper operation. | + | #Проверьте все оборудование на правильность работы. |
| | | |
− | ==Module shut-off and deinstallation procedure== | + | ==Отключение модуля и процедура демонтажа== |
− | #Disconnect the CAN connector. | + | #Отсоедините разъем CAN |
− | #Disconnect the X1-X4 connectors. | + | #Отсоедините разъемы X1-X4. |
− | #Remove the module from the DIN rail, releasing the latch at the bottom of the module base. | + | #Снимите модуль с DIN-рейки, освободив защелку, расположенную в нижней части основания модуля. |
editor, translation-admin, translator