Translations:Security plugin settings/1/en

1. Open LT Setup, General tab, click on Plugins

2. Find Security plugin, click on Enable button to launch it

3. Then click on Configure button
4. Click on +Add zone, to set actions for alarm settings

5. Zone name - any you like, but to understand what system/sensors you will use

6. You can add different zones. All added scenarios will appear below

7. Then click on +Add device button, to add responsible sensors for the action

8. In pop-up window set sensor and settings for it and save changes

• Device type - set Arm
  
• Device - choose you sensor
  
• Name - sensors name in security plugin
  
• Recovery timeout - time in seconds, when sensor resets after an alarm is triggered, until the problem disappears (door closing, no movement)
  
• Level for alarm - range of values 1-100 for motion sensors
  

9. To watch, what the sensor is responsible for action, click on the folder. You can add some sensors into a zone
For all other zones, identic procedure

10. After settings of zones, you need to add at least one user, create a password, and set the permissions for the user
Click on the Users tab, and then on +Add

11. In pop-up window, made a settings for the user, and save changes

12. After the creation of the user, the Security plugin becomes available in-app
Open the app, click on the wi-fi icon, then on the Security icon. Will open the window with pin code confirmation
Enter the pin you created for user, and then Ok

13. In Home tab, you will see your zones, and after clicking on the right corner icon, the sensors that you set

14. In Security tab, you will see the widget

• ARM - full arming of the house with your zones
  

• Partial ARM - you can choose one or some zones for arming
  

• Disarm - disarming the house
  

• Armed - house under protection
  

• Alarm - when sensors are triggering, the widget will turn Red and push-notification sent to your phone
  

• To reset the sensors, click on Alarm button, Reset sensors and Ok
  

15. Also, you can set the scenarios for the Partial arm. For that, you need to go settings of the Security plugin
On your zone, click on +Add device

16. In pop-up window, click on Device type - in drop-down list choose Arm
New fields will be appears

17. Click on +Add mode. In the new window, set any name you like, Save settings and your mode will appear below

18. After that, you can set the mode for your zones. For example day/night, and Save settings

19. Open app, enter in Security plugin, move to Partial arm
Your modes will appear in the drop-down list

20. Click on the mode you want to arm and then Ok. The system will be activated

21. To see, what zones are actually enabled, click on the Home tab

22. Do the same with another mode - Night, in our case. And your settings will be activated

23. Check the settings in Home tab