editor, Interface administrators, Administrators, translation-admin, translator
9,750
edits
Changes
mLine 37:
Line 37: − + + + + + + + + Line 55:
Line 62: − + − + Line 63:
Line 70: − + − +
Add RGB connection scheme
[[File:LED-AMP_connection_scheme.png|800px]]
[[File:LED-AMP_connection_scheme.png|800px]]
==Module parameters== <!--T:7-->
==RGB connection scheme== <!--T:7-->
<!--T:8-->
<div class="caution">CAUTION! Output channels should only be connected using amplifier which uses 5V PWM signal from IO output as input</div>
[[File:IOC_RGB_EX.png|600px]]
==Module parameters== <!--T:9-->
<!--T:10-->
<!--T:10-->
}}
}}
==Module installation and connection procedure== <!--T:8-->
==Module installation and connection procedure== <!--T:11-->
<!--T:9-->
<!--T:12-->
#Connect the outputs.
#Connect the outputs.
#Configure the module using LT setup.
#Configure the module using LT setup.
#Check all equipment for proper operation.
#Check all equipment for proper operation.
==Module shut-off and deinstallation procedure== <!--T:10-->
==Module shut-off and deinstallation procedure== <!--T:13-->
<!--T:11-->
<!--T:14-->
#Disconnect the power from the load.
#Disconnect the power from the load.
#Disconnect the outputs.
#Disconnect the outputs.