Changes

2,730 bytes added ,  08:07, 22 July 2021
Line 487: Line 487:  
#Disconnect the connectors (8)-(14).
 
#Disconnect the connectors (8)-(14).
 
#Remove the module from the DIN-rail, releasing the latch at the bottom of the module base.
 
#Remove the module from the DIN-rail, releasing the latch at the bottom of the module base.
 +
 +
==Hardware setup==
 +
 +
To configure and control METAFORSA SMART HOUSE, you must install Larnitech software on your smartphone or tablet, which is available in [https://itunes.apple.com/us/app/larnitech/id1108457530?mt=8 App Store] and [https://play.google.com/store/apps/details?id=com.larnitech Play Market]. After installation, follow the '''System Setup Instructions'''.
 +
 +
==Fault diagnostics and handling==
 +
 +
The following are some possible faults and ways of fault handling. If you have any difficulty, or face the fault undeclared here, please contact the Technical Support: [http://www.larnitech.com/support/] or [support@larnitech.com].
 +
There are also some tips in the FAQ section at our website [http://www.larnitech.com/faq/].
 +
 +
===The actuators do not operate:===
 +
 +
*ensure the outputs are properly configured in the application (see '''System Setup Instructions''');
 +
*check the connection is correct in accordance with '''table 2 and''' paragraph 3.6;
 +
*ensure the power is supplied to the input power contact , i.e. all circuit breaker assembly are ON.
 +
*verify the operability of the connected equipment.
 +
 +
===The module is off, indication absent:===
 +
 +
*check the connection to 24V supply unit as shown in '''table 2''' (contacts pin assignment);
 +
*check the connection of the supply unit to 220V power mains, the indicator should be ON.
 +
 +
===Network connection fault:===
 +
 +
*ensure the Ethernet cable is properly wired and connected to the connector;
 +
*ensure the LED status indicators are ON on the Ethernet connector;
 +
*check the LAN configuration is correct, Ethernet cable loops are absent;
 +
*METAFORSA module and the device you are connecting from are in the same network.
 +
 +
hold integer 0-10000 1-10 by default hold is the same as runtime
 +
hold is the bridging time in miliseconds, is used for gate and jalousie, lock; Example: hold=3500
 +
 +
 +
===The sensors do not operate:===
 +
 +
*ensure the inputs are properly configured in the application ('''System Setup Instructions''');
 +
*check the connection is correct in accordance with '''table 2''' and paragraph 3.7;
 +
*ensure the METAFORSA module is ON: circuit breaker assembly is closed, indication on the supply unit is ON, the module indication corresponds to the operating status – '''table 3''';
 +
*check the power supply availability on the sensors;
 +
*check the integrity of lines laid to the sensors.
 +
 +
===The auxiliary equipment does not operate:===
 +
 +
*check the connection is correct in accordance with table 2 and paragraph 3.8-9;
 +
*ensure the METAFORSA module is ON: circuit breaker assembly is closed, indication on the supply unit is ON, the module indication corresponds to the operating status – table 3;
 +
*check the integrity of the CAN lines, voltage supply on the modules.