editor, Interface administrators, Administrators, translation-admin, translator
9,749
edits
Changes
Jump to navigation
Jump to search
mLine 5:
Line 5: − + Line 13:
Line 13: − + Line 35:
Line 35: − + − ==Example of connection RGB LED with Amp== <!--T:7-->+ − − <!--T:8--> − [[File:RGBC EXA2.png|500px]] − − − + Line 54:
Line 49: − | bustype = CAN (4-wire) Line 63:
Line 57: − + − + − #Connect the CAN connector. − + − + − #Disconnect the CAN connector. − +
Updating page
| image = LED-DRV_3A.png
| image = LED-DRV_3A.png
| outCount = 4
| outCount = 4
| peakl = 2A
| peakl = 3A
| voltage = 12/24 V DC
| voltage = 12/24 V DC
| dim = ??x??x?? mm
| dim = ??x??x?? mm
<!--T:3-->
<!--T:3-->
This module allows interpreting controlling signal from DW-IO for 12/24V LED/RGB strip.
This module allows interpretation of controlling signals from IO connections for 12/24V LED/RGB strips.
<!--T:4-->
<!--T:4-->
<!--T:6-->
<!--T:6-->
[[File:RGBC EXA.png|500px]]
[[File:LED-DRV_connection_scheme.png|800px]]
==Module parameters== <!--T:7-->
==Module parameters== <!--T:9-->
<!--T:10-->
<!--T:10-->
{{ Mp
{{ Mp
| outqty = 3
| outqty = 4
| involtage = 11.5 … 25V
| involtage = 11.5 … 25V
| currtype = DC
| currtype = DC
| power = 11.5 … 27.5 V DC from CAN
| power = 11.5 … 27.5 V DC from CAN
| maxcur24v = 25 mA
| maxcur24v = 25 mA
| instalation = Free
| instalation = Free
| case = ABS
| case = ABS
}}
}}
==Module installation and connection procedure== <!--T:11-->
==Module installation and connection procedure== <!--T:8-->
<!--T:12-->
<!--T:9-->
#Connect the outputs.
#Connect the outputs.
#Configure the module using LT setup.
#Configure the module using LT setup.
#Apply power to the load.
#Apply power to the load.
#Check all equipment for proper operation.
#Check all equipment for proper operation.
==Module shut-off and deinstallation procedure== <!--T:13-->
==Module shut-off and deinstallation procedure== <!--T:10-->
<!--T:14-->
<!--T:11-->
#Disconnect the power from the load.
#Disconnect the power from the load.
#Disconnect the outputs.
#Disconnect the outputs.
==HW settings== <!--T:15-->
==HW settings== <!--T:12-->
{|class="wikitable"
{|class="wikitable"
|-
|-