Changes

m
Updating page
Line 5: Line 5:  
| image      = LED-DRV_3A.png
 
| image      = LED-DRV_3A.png
 
| outCount  = 4
 
| outCount  = 4
| peakl      = 2A
+
| peakl      = 3A
 
| voltage    = 12/24 V DC
 
| voltage    = 12/24 V DC
 
| dim        = ??x??x?? mm
 
| dim        = ??x??x?? mm
Line 13: Line 13:     
<!--T:3-->
 
<!--T:3-->
This module allows interpreting controlling signal from DW-IO for 12/24V LED/RGB strip.
+
This module allows interpretation of controlling signals from IO connections for 12/24V LED/RGB strips.
    
<!--T:4-->
 
<!--T:4-->
Line 35: Line 35:     
<!--T:6-->
 
<!--T:6-->
[[File:RGBC EXA.png|500px]]
+
[[File:LED-DRV_connection_scheme.png|800px]]
   −
==Example of connection RGB LED with Amp== <!--T:7-->
+
==Module parameters== <!--T:7-->
 
  −
<!--T:8-->
  −
[[File:RGBC EXA2.png|500px]]
  −
 
  −
==Module parameters== <!--T:9-->
      
<!--T:10-->
 
<!--T:10-->
 
{{ Mp
 
{{ Mp
| outqty          = 3
+
| outqty          = 4
 
| involtage      = 11.5 … 25V
 
| involtage      = 11.5 … 25V
 
| currtype        = DC
 
| currtype        = DC
Line 54: Line 49:  
| power          = 11.5 … 27.5 V DC from CAN
 
| power          = 11.5 … 27.5 V DC from CAN
 
| maxcur24v      = 25 mA
 
| maxcur24v      = 25 mA
| bustype        = CAN (4-wire)
   
| instalation    = Free
 
| instalation    = Free
 
| case            = ABS
 
| case            = ABS
Line 63: Line 57:  
}}
 
}}
   −
==Module installation and connection procedure== <!--T:11-->
+
==Module installation and connection procedure== <!--T:8-->
   −
<!--T:12-->
+
<!--T:9-->
 
#Connect the outputs.
 
#Connect the outputs.
#Connect the CAN connector.
   
#Configure the module using LT setup.
 
#Configure the module using LT setup.
 
#Apply power to the load.
 
#Apply power to the load.
 
#Check all equipment for proper operation.
 
#Check all equipment for proper operation.
   −
==Module shut-off and deinstallation procedure== <!--T:13-->
+
==Module shut-off and deinstallation procedure== <!--T:10-->
   −
<!--T:14-->
+
<!--T:11-->
 
#Disconnect the power from the load.
 
#Disconnect the power from the load.
#Disconnect the CAN connector.
   
#Disconnect the outputs.
 
#Disconnect the outputs.
   −
==HW settings== <!--T:15-->
+
==HW settings== <!--T:12-->
 
{|class="wikitable"
 
{|class="wikitable"
 
|-
 
|-
editor, Interface administrators, Administrators, translation-admin, translator
9,750

edits